Тепл. подуш, 80x40 д мед.проц. (термопод)

Thermal impedance: 0.04 C-cm2/W Phase change temperature: within 45℃ Storage method: refrigerated storage Scope of application: heat transfer of electronic components Method: attached to the surface of the heating or radiator Size:80*40*0.2mm Weight: 10 grams This product is a phase change material. During air transportation, the aircraft cabin and local climate may cause slight deformation of the edges of the product, which does not affect normal use. If you cannot accept it, please do not buy it. Thoroughly clean the chip surface and the contact surface of the heat sink. It is recommended to use the complimentary alcohol wipes. Important points) If it is to be attached to the surface of a chip, it must be cut to the same size as the chip, or even slightly smaller by one edge. Only by sticking the edges firmly and not hanging in the air can the film be easily peeled off. If it is attached to the base of the radiator, it is recommended that it be a circle larger than the chip to facilitate aiming, and do not cover the uneven protrusions. The film can be easily peeled off on a flat surface! But no matter which surface it is attached to, the edge cannot be suspended, so that the next step can be easily operated. Uneven edges and dangling edges will make it difficult to peel off the film; Tear off one side of the release film and stick it to the base of the radiator or the chip surface (do not repeatedly knead the phase change film before use. If the room temperature is too high, you can put it in the refrigerator for ten minutes. It will be easier to peel off the film after cooling); Then use your thumb to apply evenly on the entire surface of the phase change film to fully adhere the phase change film so that the film can be peeled off in the next step; Tear off the other half of the release film. It is