Сварочный пистолет, сварочная станция, ремонтный инструмент…

Operation Connect the hot stapler to a power socket. Clamp a hot staple with the plier and install the staple into the copper tube. Make sure that the staple is pushed all the way in Press the hot staple on the crack and make sure that the hot staple intersects with the crack. Press and hold the activation trigger until the staple melts into the plastic When the plastic solidifies, release the activation trigger. Then, pull the hot stapler to separate Repeat the above procedures until the crack is fully stapled Use a plier to cut off the excess staple leads NOTICE During the operation, DO NOT touch the hot staple and copper tube DO NOT attempt to remove the hot staple leads with bare hands to avoid potential cut injuries on your hand