М01 Замок с отпечатком USB, без ключа, для чемодана, красный

Ideal for homes, gates, factories, offices, bikes, bags, suitcases, cabinets, dorms, staff lounges, hospitals, food boxes, trucks, public lockers. Specification: Model: M01 Color: Red, Black, Blue (optional) Battery capacity: 110mAh 3.7V Operating temperature: -20 ~ +70 ℃ Input power: DC 5V 200mA Working voltage: 3.0 ~ 4.2V Material: zinc alloy Locking mode: fingerprint Status indicator: three-color LED Stored fingerprints: 10 Charging time: 1-2 hours Charging interface: Micro USB Locking times after full charge: 1000 Max standby: 6 months Low power alarm: Red light flashes 6s after unlocking Working temp: -20 ~ 70 ℃ Size: 70 x 23 mm Net weight: 60 g First admin fingerprint: Press and hold sensor 5s until blue light on; release; green light flashes and wait; press same fingerprint >5 times. Red light if fail. Green light long indicates success. Fingerprint entries No.2~10: Admin authorization required. Second is admin; 3~10 are users. Press and hold sensor 5s until blue light on; release; blue stays on to verify admin. If admin fails, red light flashes; try again. If admin succeeds, green light flashes and other fingerprints can be entered. Press same fingerprint >5 times. Red flash = fail; green stays on = success. Restore factory settings: Deleting fingerprints requires admin: Press sensor 8s until blue flashes and goes out, red on, admin verified quickly; If admin fails, red flashes and delete fails; If success, green flashes and all fingerprints are deleted (factory reset). Charging / emergency: When low power prompt appears, charge ASAP. If power is too low to unlock, use bottom micro USB to power on and unlock. Notice: Micro-USB charging; fully charge before use. Supports 10 fingerprints: 1~2 admins, 3~10 users. Factory reset clears all fingerprints including admins. Factory default mode unlocks with any fingerprint. Note: Color may vary slightly due to monitor/light. Please allow 1-2 cm measurement deviation. 1 x Fingerprint Padlock